電熱培養箱：電熱恒溫鼓風干燥箱應該怎么使用呢？操作方法是什么呢？下面，我們一起了解一下吧!

Electrothermal incubator: How should the electrothermal constant temperature blast dryer be used? What is the method of operation? Next, let's solve it together.

1、干燥箱內嚴禁放入易燃、易揮發物品，以防爆炸。

1. Flammable and volatile substances are strictly prohibited in the drying box to prevent explosion.

2、用專用的插頭插座，并用比電源線粗一倍之導線接地。使用前檢查電氣絕緣性能，并注意有否斷路、短路及漏電現象。

2. Use special plugs and sockets and grounding with conductors twice as thick as power lines. Check the electrical insulation performance before use, and pay attention to whether there are open circuit, short circuit and leakage phenomenon.

3、箱上放入溫度計，打開電源調節溫控旋鈕到設定溫度，至交流接觸開關剛好斷開時檢查溫度計的讀數與設定值是否相符，如果有出入則進行微調，直至恒溫溫度符合設置溫度。

3. Put a thermometer on the box, turn on the power supply to adjust the temperature control knob to the set temperature, check whether the thermometer reading is consistent with the set value when the AC contact switch is just disconnected, and fine-tune if there is any discrepancy, until the constant temperature meets the set temperature.

4、打開頂部或底部排氣孔排除箱內濕氣。

4. Open the top or bottom vents to remove moisture from the box.

5、試品鋼板更大平均負荷為15Kg，放置切勿過重、過密，一定要留有空隙，工作室底板上不能放置試品。

5. The average load of the test plate is 15 Kg. Do not place it too heavy or too close. There must be a gap. The test plate can not be placed on the floor of the studio.

6、通上電源，綠色指示燈亮，開啟鼓風開關，鼓風電機運轉，開啟加熱電源，干燥箱即進入工作狀態。

6. Turn on the power supply, turn on the green light, turn on the blower switch, turn on the blower motor, turn on the heating power supply, and the drying box will enter the working state.

7、工作時，箱門不宜經常打開，以免影響恒溫場。

7. When working, the door should not be opened frequently to avoid affecting the constant temperature field.

以上就是電熱培養箱廠家給大家帶來的資訊介紹，了解更多的相關知識介紹，歡迎關注我們的官方網站。

Above is the introduction of information brought to you by the manufacturers of electric heating incubators, to learn more about the introduction of relevant knowledge, welcome to pay attention to our official website.

http://www.crxyq.cn