(1)電熱培養箱應由專職人員執掌,實際操作盤里的不管怎樣電源開關和調整旋扭一日固定不動后,不必隨心所欲晃動,以防危害箱里溫度,co2、潮濕水平的接動,另外降低設備的銳敏度。
(1) The electric heating incubator should be handled by full-time personnel. No matter how the power switch and the adjusting twist in the actual operating plate are fixed for one day, it is not necessary to shake at will in order to prevent harming the temperature, CO2 and humidity level in the incubator, and to reduce the sensitivity of the equipment.
(2)所報名參加的水盡量是純凈水或無齋子水,防止礦事情存儲積累在裝水的小箱子內萌發浸蝕效應。歷年盡量換一回水。經常查緝箱里水是不是夠
(2) The water registered for participation should be pure water or non-Zhaizi water as far as possible, so as to prevent the erosion effect of mineral storage accumulating in small boxes filled with water. Change the water as much as possible over the years. Check regularly whether the water in the seizure box is enough.
(3)箱內部策應定期用消毒液洗擦消毒↓擱板可抽取清洗消毒,避免其他微有生命的物質污染,造成實驗敗績。
(3) The internal policy of the box should be regularly scrubbed and disinfected with disinfectant_shelf can be extracted, cleaned and disinfected to avoid other micro-living substances pollution, resulting in experimental failure.
(4)按時查緝過熱保險裝置,防止過熱。方法為按進監控檢驗警報按扭,旋轉固定不動螺絲,始終到過熱警報系統響,然后關掉過熱保險燈。
(4) Search and seize the overheating insurance device on time to prevent overheating. The method is to check the alarm by pressing, rotating and fixing the fixed screw until the overheating alarm system sounds, and then turn off the overheating safety lamp.
(5)如長時期不運用碳酸氣時,應將CO2開關關閉,避免CO2調節器不起作用。
(5) If the carbonate gas is not used for a long time, the CO2 switch should be turned off to avoid the failure of the CO2 regulator.
(6)所應用的CO2盡量的純粹的,不然降低CO2控制器的銳敏度和環境污染CO2過淋設備。
(6) The CO2 used is as pure as possible, otherwise the sensitivity of the CO2 controller and the environmental pollution of the CO2 leaching equipment will be reduced.
(7)在無濕潤程度扼制的培育箱內,為維持箱內CO2的牢穩,要在稍內底層放入一個盛水的容培育箱
(7) To maintain the stability of CO2 in the incubator, a water-holding incubator should be placed at the bottom of the incubator.http://www.crxyq.cn