在使用恒溫恒濕培養箱的時候，我們應該怎么控制好它的溫度呢，下面讓恒溫恒濕培養箱廠家帶大家了解一下控制恒溫恒濕培養箱的六個步驟。

When using constant temperature and humidity incubator, how should we control its temperature? Let the incubator manufacturer show you six steps to control constant temperature and humidity incubator.

一、溫度控制：

1. Temperature control:

產品出廠前已經將溫度置定在37 ℃。如果要求恒溫培養箱工作溫度37℃，只要按下電源開關即可運行。

The temperature of the product has been set at 37 C before leaving the factory. If the constant temperature incubator is required to work at 37 C, it can be operated by pressing the power switch.

二、按下電源開關，兩秒鐘后溫度顯示窗會顯示工作室的當前溫度。

2. Press the power switch. After two seconds, the temperature display window will show the current temperature of the studio.

三、工作室溫度設置：

3. Studio temperature setting:

操作溫度設置模式選擇鍵，能使溫度控制系統分別進入溫度設置模式、水溫修正設置模式、溫度檢測控制模式。

Operating temperature setting mode selection key can make the temperature control system enter temperature setting mode, water temperature correction setting mode and temperature detection control mode respectively.

四、按下溫度設置模式選擇鍵兩秒鐘后松開，這時溫度設置狀態指示燈亮，同時溫度顯示窗數字閃爍地顯示出設定的溫度，表示進入溫度設置狀況。

4. Press the Temperature Setting Mode Selection Key and release it two seconds later. Then the Temperature Setting Status Indicator lights up. At the same time, the Temperature Display Window displays the set temperature with digital flicker, indicating that it is in the Temperature Setting State.

五、培養箱水套采用不銹鋼氬弧焊制作經久耐用，隔水式加溫方式，溫度均勻且斷點后仍能保持較長時間恒溫。

5. The water jacket of the incubator is made of stainless steel by argon arc welding, which is durable and water-proof heating mode. The temperature is uniform and can remain constant for a long time after the breakpoint.

六、溫儀采用高速、高性能CPU處理芯片，高靈敏、高精度鉑電阻傳感器，具有定時開機、定時關閉、定值工作的固定編程控制功能。

6. The thermometer adopts high-speed and high-performance CPU processing chip, high-sensitivity and high-precision platinum resistance sensor. It has fixed programming control functions of timing start-up, timing shutdown and fixed-value operation.

定時時間長達99小時。

The timing lasts up to 99 hours. http://www.crxyq.cn/